4.11 see fig.13.
now start to build the second low level unit by
making up two end frames as shown in fig.13. one short 'Z'
beam (c) should be fixed at the top of the angle posts and the
other short 'Z' beam (c) should be fixed at the 7th and 8th
keyholes up from the bottom of the angle posts as shown below.
Ensure that each 'Z' beam is facing upwards. tap the beam
at either end, close to each angle post with a rubber mallet to
ensure that the rivets are seated at the bottom of the keyhole slots.
4.12 see fig.14.
Join the two end frames together using the four
remaining long 'Z' beams as shown above. Ensure that each 'Z'
beam is facing upwards. tap the beams at either end, close to
each angle post with a rubber mallet to ensure that the rivets are
seated at the bottom of the keyhole slots.
4.13 see fig.15.
Lay the shelves into position between the 'Z' beams
as shown above.
4.14 see fig.16.
Place the two units end to end as shown below and
join them together using the 2 post clips (G). Insert a post cap
(E) into the top of each 'A' post.
fig.12
fig.13
fig.14
fig.15
fig.16
01284 757500
01284 703534
sales@sealey.co.uk
sole uk Distributor
sealey group,
Bury st. Edmunds, suffolk.
www.sealey.co.uk
Web
4.10 half height stORage statiOn. see fig.12.
follow steps
4.2 and 4.3 to create a bottom frame with four 'A' posts attached.
using two long 'Z' beams (B) and two short 'Z' beams (c) build a
shelf support level at the top of the angle posts (A). tap the
beams at either end, close to each angle post with a rubber
mallet to ensure that the rivets are seated at the bottom of the
keyhole slots. Build another shelf support level at the desired height
within the frame using additional long and short 'Z' beams and
ensure that the rivets are seated at the bottom of the keyhole slots.
AP6548
IssuE no:1 26/06/08
