1 DraWer/2 Door cabINet WItH Work top:
raIl types:
step 1:
Fit feet.
step 2:
Attach 2x cabinet rails to the back of the base
cabinet using 3x M6x16mm screws per rail.
step 3:
Slide 2x peg board rails fully onto the cabinet posts.
Place one pegboard on the front, making sure the grommet hole is on
the bottom. Attach using 2x M6x16mm screws per rail.
to remoVe DraWers
P
ull drawer out so it’s almost fully extended.
Push up right hand black release lever, while
pulling down left hand black release lever,
pull the drawer out until it is released from
the slides.
to replace DraWers
e
xtend the drawer slides. Insert the brackets
on each side of the drawer into the slots in
the cabinet slides, being careful to ensure
that they are properly positioned. once
properly inserted, completely close
The drawer to set the slides in their proper
positions.
APMSHFP series | Issue 1 21/10/19
Original Language Version
© Jack Sealey limited
cabinet
rail x8
adjustable feet
pegboard x1
pegboard rail x2
m6x16mm
screw x4
pegboard rail
x4
pegboard x4
