2. introduction
Heavy-duty 7 tonne short axle stands. sturdy welded steel construction for superior safety and strength, which helps prevent distortion and
twisting. large saddles for good load distribution. supplied with captive pin load support. suitable for use with forklifts and vehicles with low
suspension. sold in pairs
3. specification
Model no ......................................................................as7s
capacity each ......................................... 7 tonnes (7,000 kg)
capacity Pair ....................................... 14 tonnes (14,000 kg)
minimum Height ......................................................... 245mm
maximum Height ........................................................ 355mm
4. operation
4.1. familiarise yourself with the product. check that the stands are in good condition
and that no damaged has been sustained during transit.
4.2. ensure the maximum load does not exceed 14 tonne per pair of axle stands,
(7 tonnes for each stand).
4.3. refer to vehicle manufactures instructions for recommended support points. check
that the points are in good condition.
4.4. ensure the vehicle brake is on (or in park mode) and wheels are chocked.
4.5. Adjust height of stand to correspond with the raised vehicle.
4.6. check that the locking pin is correctly pushed all the way through the centre column and out of the other
side see fig.1, then position
stands under vehicle at points recommended by vehicle manufacturer.
4.7. carefully and slowly lower the load onto stands. ensure the load bearing points sit in the center of the stand saddle and check that the
stands are stable and not leaning. Also ensure that there are no objects or persons that could impede the safe lowering of the vehicle
onto the stands.
4.8. to remove stands jack vehicle slightly so that stand can be removed.
4.9.
After use, hold the centre column (fig.1.1) firmly when removing the locking pin (fig.1.3). Failure to do so will
allow the center column
to fall freely through the main center tube (fig.1.2) which could be dangerous.
WarninG!
ensure you follow all instructions carefully. failure to note these warnings may cause damage, serious injury or loss of life.
5. Maintenance
5.1. Before each use check to ensure stands and stand welds are not cracked, and that there are no missing and/or damaged parts.
WarninG!
Any stand that appears to be damaged in any way must be removed from service immediately.
5.2. ensure the locking pins, are in good order and condition.
5.3. Due to the potential hazards associated with these stands, do not misuse, or make any modification to the stands or components.
5.4. it is the responsibility of the stands owner to ensure the operator has read these instructions, and that the operator is familiar with the
stands use and limitations.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMportant:
no liability is accepted for incorrect use of this product.
Warranty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
www.sealey.co.uk
sales@sealey.co.uk
01284 757500
01284 703534
As7s.V2 | issue 1 05/05/17
Original Language Version
© Jack sealey limited
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
fig.1
