WARNING:
Read and adhere to instructions and safety guidelines provided with your choice of electrolyte.
NOTE:
Only use electrolytic powder that is 90% pure.
NOTE:
Mix ratio of electrolytic powder to water is 1:10.
1.3.
FLUID SAFETY
▲
CAUTION:
Harmful if swallowed.
▲
CAUTION:
Causes severe skin burns and eye damage.
8
DO NOT
breathe vapour.
8
DO NOT
eat, drink or smoke when using this product.
9
Wash hands and other skin areas exposed thoroughly after handling.
8
DO NOT
eat, drink or smoke when using this product.
9
Wear protective gloves/protective clothing/eye protection/face protection.
WARNING:
IF SWALLOWED: Rinse mouth.
DO NOT
induce vomiting. Immediately call a POISON CENTRE or doctor.
WARNING:
IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse cautiously with water for several
minutes
WARNING:
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
Continue rinsing.
9
Wash contaminated clothing before reuse.
9
Specific treatment: Contact a POISON CENTRE or doctor.
9
Store locked up.
9
Dispose of contents and containers in accordance with national and local regulations.
2. INTRODUCTION
The Sealey CC230V uses cutting edge HHO engine cleaning technology. Each unit uses electrolysis to split water molecules into the
composite elements of oxygen and hydrogen to produce oxyhydrogen or HHO gas. Simple to use machine feeds HHO into the engine
through the vehicle air inlet breaking down any carbon build up on its way. Carbon builds up layer on layer when fuel combusts in the engine
cylinders which can affect the smooth running of any engine. Removing carbon build up from the engine can improve performance, raise
mpg, reduce emissions and oil consumption. The CC230V runs on tap water with no expensive refills making the process a great revenue
boost for any workshop. Fitted with CAMS ( Charge Activated Machine Shutdown ) designed to safely cut-out if the engine stops running
during treatment. Also meaning the unit can be left to run without supervision allowing the user to continue with other work.
3. SPECIFICATION
MODEL NO: .............................................................CC230V
Cells ...............................3 x 3 Raid Technology (Generators)
D
imensions (W x D x H)
..........................
350 x 650 x 860mm
Flow Rate: ..................................................................
600L/hr
Power ...........................................................................
1.4kW
Supply ................................................................. 230V~50Hz
Power ...........................................................................
1.4kW
Tank Size ...........................................................................
8L
4. ASSEMBLY
4.1.
Remove parts from packaging and check to ensure they are complete and not damaged.
4.2.
Connect CAMS safety cable (fig.1) to the socket on the control panel (fig.2).
4.3.
Connect the gas hose and tap assembly on rear face of unit (fig.3) if not already fitted.
4.4.
Check liquid level indicator on rear face of unit (fig.3). If level is at the lower level, the tanks need topping up.
4.5.
To top up, unscrew filler cap (fig.1) Use a funnel and slowly and carefully add 100 ml of 1:10 electrolyte solution at a time until the
level is approximately 1/3rd distance from the top of the liquid level indicator.
DO NOT
overfill the unit.
4.6.
Avoid creating air locks by adding the solution very slowly. If air locks are discovered, gently rock the unit to rectify.
4.7.
Ensure the filler cap is re-fitted properly to avoid any leakage.
Original Language Version
© Jack Sealey Limited
C
C230V Issue 1 15/05/2020
fig.1
fig.2
