4. OPERATION
4.1.
CHARGING
4.1.1.
Plug the USB lead into the micro USB port (fig.1).
4.1.2.
Connect the USB lead into a 5V dc outlet.
4.1.3.
When charging commences, the charge indicator will light.
4.1.4.
As the charge builds, the LEDs will light in sequence until the green shows, denoting a full charge. The amber LED represents mid-
charge.
4.1.5.
When fully charged, remove the USB lead from the screwdriver and the power outlet.
4.2.
Charge level
4.2.1.
When the tool is operated, the display shows the charge level: full charge is shown by all three LEDs being lit. The number of lit LEDs
reduces with the charge level. When just the red shows, the tool requires recharging as in section 4.1.
4.3.
Operation
4.3.1.
Pressing the trigger (fig.1) will actuate the screwdriver. Sliding the forward /reverse selector will change the direction of rotation.
4.3.2.
Pressing the trigger will also switch the LED worklight on.
4.4.
Changing bits
fig.2
fig.3
4.4.1.
The CP36MS is supplied with two magazines containing screwdriver bits. To change a bit which is contained in the fitted magazine, pull
the magazine carrier forward (fig.2) and rotate the magazine until the required bit is at the top. The bit to be loaded may be viewed
through the magazine viewer.
4.4.2.
To load the chosen bit, pull the magazine carrier back toward the handle.
4.4.3.
To change the magazine, pull the magazine carrier forward and push the magazine to the left until it hangs below the screwdriver
then pull the magazine forward until released from the spindle (fig.3).
4.4.4.
Place the alternative magazine on the spindle and swing it back into the magazine carrier.
4.4.5.
Push the magazine carrier back as in 4.4.2.
!
Important Warranty Information
The battery fitted to this cordless tool is considered to be a consumable item and its ability to accept charge will diminish over time. Our
warranty will cover genuine battery malfunction, but not fair wear and tear, for a period of 12 months.
CP36MS Issue: 2(F) - 29/11/17
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
