fig.3
5. OPERATION
5.1.
USING THE POLISHER
WARNING!
Ensure you read, understand and apply the safety instructions in Section 1.
5.1.1
Select required polishing/sanding head and screw (clockwise) onto drive spindle, the spindle can be locked by depressing the
spindle lock. fig.3.
5.1.2 Hold the polisher firmly with one hand on the handle grip and the other on the Side-Handle. To select the required speed slide the
speed selection switch forward or back to select either high or low speed range. fig.3.
5.1.3 To start the polisher gradually press the trigger when in the fully depressed state it can be locked on by sliding the trigger lock to
stop the polisher push lock in opposite direction and release trigger. fig.3.
5.1.4 Lock the spindle and turn the polishing/sanding head anti-clockwise
WARNING!
The high speed settings are intended for sanding. If used for polishing an excessive amount of surface material may be
removed.
5.1.5 Keep the machine clean and dry. Do not use abrasives to clean the unit.
WARNING!
Wear approved safety eye protection and, if necessary, respiratory protection.
Note. maintenance must only be carried out by a technically qualified person or an authorised service agent.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
sales@sealey.co.uk
01284 757500
01284 703534
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Battery Removal
See section 4.1
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered wih Valpak’s
registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
© Jack Sealey Limited
Original Language Version
CP6005, CP6015 Issue: 1 - 28/02/17
