3.2.
Blade fitting
Note:
Always ensure that battery is removed from saw before fitting or removing the blade.
3.2.1. Loosen clamp screw (1) with hex. key provided.
3.2.2. With cutting teeth facing forward and back of blade against guide roller, slide blade into
blade holder (2) as far as possible - approx. 10mm. - and tighten clamp screw.
3.3.
Sawing
Note:
The jig saw has a safety lock-off device to prevent the saw from being switched on accidentally.
3.3.1. To start the jig saw, press and hold the red safety lock-off button (A) and then squeeze the On trigger switch (B).
The saw will start. Release the lock-off button. Note: There is a safety button on each side of the hand grip to
allow right or left handed use.
3.3.2. To stop the saw release the On switch, which will be automatically locked-off for safety.
3.3.3. With the jig saw switched off, place the rest plate of the saw against the work piece, with the blade
either at the edge or through a starter hole. Switch on the saw and commence cutting.
3.3.4. When the cutting power starts to decrease, re-charge the saw battery to prevent complete discharge.
p
WARNING!
The trigger switch and the lock-off switches are not to be removed or tampered with, e.g. by tying down the
trigger switch to the handle, or the saw will not switch off automatically, or will not lock-off, and there will be a high risk of injury.
Important!
Wear safety goggles and a mask to prevent eye injury and dust inhalation.
CP9912VJ - 0064 - (1) - 040699
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 757500
E-mail:
sales@sealey.co.uk
01284 703534
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue, call us on 01284 757525 and leave your full name and address, including postcode.
Declaration of Conformity
We, the sole importer into the UK, declare that the products listed below are in conformity withthe following EEC standards and directives.
The construction files for these products are held by the Manufacturer and
may be inspected on request by contacting Jack Sealey Ltd.
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Tools.
Signed by Mark Sweetman
1st June 1999
Cordless Jig Saw & Charging Unit
Model CP9912VJ
73.23/EEC Low Voltage Directive (S.I. 1994/3260)
89/336/EEC EMC Directive
4. CLEANING & STORAGE
4.1.
To prolong the useful life of the battery-powered jig saw always clean it thoroughly after use.
Important!
Never clean with running water, and certainly not with high pressure jet. Risk of injury to persons and damage to property.
4.2.
Keep the jig saw in a dry, cool - but frost-free - and childproof place.
Cordless Jig Saw & Charging Unit
Model CP9912VJ
73/23/EEC Low Voltage Directive (S.I. 1994/3260)
89/336/EEC EMC Directive
2
1
A
B
