4.9.5.
Firing next staple or nail, repeat step 4.9.3 and step 4.9.4
4.9.6.
The safety contact pin must be depressed before the trigger is squeezed.
4.10.
contact firing mode:
4.10.1.
P
ush the single/contact firing switch to the right side, it is on Contact Firing mode.
4.10.2.
C
ontact Firing is good for quick and convenient firing.
4.10.3.
S
queeze the trigger , keep squeezing and don’t release.
4.10.4.
d
epress the safety contact pin against the work piece to fire the nail or staple; Keep squeezing the trigger all the time but released
safety contact pin after firing.
4.10.5.
F
iring next staple or nail , repeat step 4.10.4
4.10.6.
The trigger must be kept depressed all the time so that every time the safety contact pin is depressed the tool is activated.
4.10.7.
do not
keep the trigger depressed when the tool is not in use.
4.10.8.
A
significantly reduced working period after charging indicated that the battery is used and must be replaced.
4.11.
depth adjustment Wheel
4.11.1.
depth adjustment helps protect work surface and allows proper setting of nail heads.
4.11.2.
T
urn the depth adjustment wheel to alter the depth of penetration of the nails/staples.
4.12.
removing a jammed nail or staple
note:
You must remove any jammed nail/staple before using the tool any further. Otherwise, it could cause damage to the mechanism.
4.12.1.
Remove the battery pack from the tool.
4.12.2.
o
pen the magazine, remove the staples or nails in channel. Then, to remove the jammed fasteners.
C
PNG18.V2 Issue 1 19/11/18
Original Language Version
© Jack Sealey limited
