There should be a strong, bright zone centred at
the zero position.
MAIN BEAM
It is recommended that the unit has periodic calibration checks. The headlamp beam setter can be recalibrated using a laser alignment
calibration unit. We recommend the Sealey AK9999 (available from your authorised Sealey dealer).
Set up the laser calibration device and level it first, the beam setter can then be manoeuvred easily on it's stand with reference to the position
of the laser. The laser can be placed on any surface such as a car bonnet, box, table etc of suitable height.
6.1.
Using the calibrated spirit level within the laser alignment calibration device, ensure that the unit is flat and level.
6.2.
Switch the laser on. Manoeuvre the beam setter in order to centre the laser beam in the beam setter lens. This must be done “by eye”.
There is a ±20mm tolerance on centralisation of the beam through the lens. The beam setter should be approximately 2m from the
laser.
6.3.
The three dots projected onto the aiming screen should bisect the 0º line, at the far left, centre and far right of the screen (fig.6). It is
necessary at this point to rotate the column through the vertical axis, to track the beam from one side of the aiming screen to the other.
Take care to ensure that the laser and the beam setter both remain level throughout.
Alignment OK
Adjust screen
6.4.
If it is necessary to adjust the screen, unscrew the two retaining screws holding the top clear cover in place and remove it.
6.5.
Slightly loosen the two screws holding the screen in place, reposition the screen so that the projected laser dots correctly bisect the 0º
line.
6.6.
Retighten the screws, taking care not to move the screen out of position. Re-check to confirm it is still aligned correctly and then re-fit
the top cover and two screws.
7.1.
Clean with a slightly dampened cloth, being especially careful with the lens so as not to damage it.
7.2.
DO NOT
leave the machine in areas where corrosive vapour is present, i.e. from battery charging or paint spraying etc.
7.3.
DO NOT
oil the column.
7.4.
When not in use store Beam Setter in a safe, dry, childproof location.
fig.5
fig.6
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.
Original Language Version
HBS2010.V2 Issue: 2 - 07/01/16
© Jack Sealey Limited
6. CALIBRATION
7. MAINTENANCE
will appear brighter than the rest of the projection.
5.2.13. Switch the headlamps on to main beam. They should be aimed so that the beam image centre is on the Zero position (fig.5). Adjust if
necessary.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534
sales@sealey.co.uk
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
