3. AIR SUPPLY
3.1.
Air Supply
recommended hook-up is shown in fig.1.
3.1.1. Ensure spray gun air valve (or trigger) is in the off position before connecting to the air supply.
3.1.2. You will require an air pressure of 43psi, and an air flow according to specification.
3.1.3.
WARNING!
Ensure the air supply is clean and does not exceed 43psi while operating the spray gun. too high an air pressure and/or
unclean air will shorten the product life due to excessive wear, and may be dangerous causing damage and/or personal injury.
3.1.4. Drain the air tank daily. Water in the air line will ruin the paint finish and damage the spray gun.
3.1.5. clean air inlet filter weekly.
3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). the minimum hose diameter should be
1/4” I.D. and fittings must have the same inside dimensions.
3.1.7. Keep hose away from heat, oil and sharp edges. check hose for wear, and make certain that all connections are secure.
3.2.
Couplings
Vibration may cause failure if a quick change coupling is connected directly to the spray gun. to overcome this, connect a leader hose to
the spray gun. A quick change coupling may then be used to connect the leader hose to the air line recoil hose (figs.1 and 2).
4. INSTRUCTIONS
4.1.
for best results, the gun should be held perpendicular to the surface being sprayed and moved parallel to it. start the stroke before
squeezing the trigger and release the trigger before finishing the stroke. this will enable accurate control of the gun and material
(Fig.3B)
.
4.2.
spray from a distance of about 6 to 10 inches (150 to 250mm) depending on the material and the atomizing pressure. the material
deposited should always be even and wet. Each stroke must overlap the preceding stroke to obtain a uniform finish. to reduce over-spray
and obtain maximum efficiency, spray with the lowest possible atomizing air pressure.
4.3.
controlling the fan spray and the fluid.
a) use the needle (paint) adjustment knob
(Fig.4.2)
to adjust the amount of paint flow.
b) the atomizing air flow is controlled by the control knob
(Fig.4.1)
.
c) the volume of air input is controlled by the adjustment knob
(Fig.4.3)
.
d) As width of spray is increased more material must pass through the gun to obtain the same coverage on the increased area.
e) turn the air nozzle
(Fig.4.4)
to achieve a horizontal or vertical fan spray. Lock the nozzle with retaining ring
(Fig.4.5)
.
the spray pattern of the gun is variable from round to flat with all patterns in between. In normal operation, the wings on the
nozzle are horizontal
(Fig.5)
. this provides a vertical fan-shaped pattern which gives maximum, uniform and even coverage when
moving the gun back and forth, parallel to the work surface
(Fig.6)
.
Fig.4
Fig.5
Fig.3A
Fig.3B
Fig.1
Fig.2
Fig.6
Original Language Version
HVLP731, HVLP741.V2, HVLP742 Issue: 2 - 12/10/09
