RECHARGEABLE PORTABLE FLOODLIGHT &
POWER BANK 20W COB LED
MODEL NO:
LED184
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or
damaged
DO NOT
use.
9
Ensure the lamp is fully charged before initial use.
8
DO NOT
charge in damp conditions.
8
DO NOT
turn the lamp on when it is being charged.
8
DO NOT
shine directly into your, another person’s or an animal’s eyes.
8
DO NOT
allow children to use the lamp.
8
DO NOT
handle or move the lamp whilst it is being charged.
8
DO NOT
use the lamp if you suspect that the battery or the lamp casing is damaged.
8
DO NOT
leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
8
DO NOT
attempt to open, disassemble, modify or service the battery pack.
8
DO NOT
crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT
expose to temperatures above 60°C (140°).
9
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with
cool water and seek immediate medical attention.
2. INTRODUCTION
P
ortable, rechargeable floodlight. Die cast aluminium housing with integral 180° adjustable
stand. COB LED technology allows ultra-bright illumination. Power switch has three
brightness settings (low, medium and high) allowing it to produce up to 1900 lumens.
Features battery level indicator and a 5V/1A USB output for charging electronic devices.
Supplied with USB charging lead.
3. SPECIFICATION
Battery: ................................................3.7V 2.0Ah Li-ion (x3)
Charging Time: ..................................................................9hr
Colour Temperature: ....................................................5000K
LED Qty: ................................................................ 20W COB
Lumen Output: .................100%/50%/25%: 1900/1100/650lm
Model No: ..................................................................
LED184
Nett Weight: ................................................................... 630g
Operating Time: ......................100%/50%/25%: 1.6/3.5/4.5hr
USB Output: ................................................................. 5V 1A
4. OPERATION
4.1.
USING THE LIGHT
4.1.1.
Turn floodlight ‘On’ and ‘Off’ by the switch on the back of the unit (fig.2).
4.1.2.
The light has three brightness settings low, medium and high. Press the On/Off
button once for low, twice for medium, and three times for high. Pressing the button
a fourth time will turn the light off.
4.2.
CHARGING THE LIGHT
WARNING!
Ensure that you read, fully understand, and apply the safety instructions
before use.
4.2.1.
Ensure the floodlight is turned ‘Off’ and then plug the USB lead into the USB socket.
Stand the floodlight in a safe location ready to charge.
4.2.2.
Plug charger into a 5V supply. The power indicator LEDs will flash blue and turn
solid in sequence as the battery charges.
Refer to
instructions
fig.1
fig.2
L
ED184 Issue: 2(4) - 03/09/18
Original Language Version
© Jack Sealey Limited
