6W COB LED + 1W LED RECHARGEABLE SLIM
INSPECTION LAMP
MODEL NO:
LED186
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1.
GENERAL
9
It is important to ensure that the lamp is fully charged before initial use.
8
DO NOT
turn the lamp on when it is being charged.
8
DO NOT
shine directly into your, another person’s or an animal’s eyes.
8
DO NOT
allow children to use the lamp.
8
DO NOT
leave battery in a discharged state. Recharge battery immediately.
9
Recharge the battery at least once every six months of non-use.
9
There are no user serviceable components.
DO NOT
dismantle.
8
DO NOT
pull the charger plug from the mains socket by the lead.
1.2.
BATTERY SAFETY
WARNING!
To reduce the risk of burns or fire:
8
DO NOT
Attempt to open, disassemble, modify or service the battery pack.
8
DO NOT
Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT
Expose to temperatures above 60°C (140°F).
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. INTRODUCTION
S
limline fold out inspection lamp for use in confined spaces with its slim 9mm thickness. Inspection arm can be rotated 180° and folded.
Features 1 COB LED, which produce up to 550 lumens and a 1W SMD LED on the end for use as a directional torch. Main light has two
different lighting modes High/Low (550lm/220lm) and the SMD spotlight which has one setting at 80lm. Suitable for hands-free operation with a
magnet and a hanging hook. Folds away, small and compact, suitable for keeping in your pocket. Powered by a 3.7V 2Ah rechargeable Li-ion
battery, which lasts up to 8 hours. Supplied with USB charging lead.
3. SPECIFICATION
Model No:.................................................................LED186
Battery: ..........................................................
3.7V 2Ah Li-ion
Charging Time: ..................................................................3hr
IP Rating: ..........................................................................IP4
LED Qty: ....................................................... 1 COB + 1 LED
Lumen Output ...............
Side(High/Low)/Top: (550/220)/80lm
Maximum Length: ......................................................
270mm
Minimum Length: ....................................................... 155mm
Operating Time:
.....................Side(High/Low)/Top: (2.5/4)/8hr
OPERATION
4. OPERATION
4.1.
CHARGING
4.1.1.
The battery fitted to this lamp is considered to be a consumable item and its ability to accept charge will reduce over time. We will
warranty it against mechanical and electrical defect for a period of one year, this does not cover fair wear and tear. If the
battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will
not replace the battery even if it is less than one year old.
4.1.2.
Connect the charger into the USB socket on the lamp. Plug in to power supply and turn on. The blue LEDs on the lamp will light as
the battery charges. When all LEDs are lit, the torch is fully charged.
4.1.3.
When the battery has fully charged (approx 3hrs) disconnect from mains supply.
NOTE:
The Lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another
charge.
L
ED186 Issue 1 23/04/2020
Original Language Version
© Jack Sealey Limited
Refer to
instructions
