4.1.4.
Unfold lamp.
4.2.
LIGHTING
MODES
4.2.1.
Press ON button to cycle through the lighting modes. Press once for COB at 220lm, twice for COB at 550lm, three presses turns
on LED at 80lm and fourth press turns torch off.
4.2.2.
If the light is left set in any mode for more than 10 seconds, the next press will turn the unit off.
4.3.
LAMP ARRANGEMENT
4.3.1.
Positioning of the lamp with respect to the torch body can be achieved by either unfolding it and rotating lamp up or down through
180
0
, twisting it through 180
0
or ‘rolling’ it to one side (fig.1). The methods may be combined to adjust to any situation.
4.3.2.
Lamp can be hung from the hook or attached using magnets.
5. MAINTENANCE
5.1.
Keep lamp clean and check for damage before every use. If damage is observed, remove from use until unit is repaired.
5.2.
The battery is not designed to be removed .
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations).
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. Please email sales@sealey.co.uk or telephone 01284 757500
Original Language Version
© Jack Sealey Limited
L
ED186 Issue 1 23/04/2020
fig.1
