NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
no liability is accepted for incorrect use of this product.
WARRANTy:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
sales@sealey.co.uk
Sole uK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
iP32 7AR
www.sealey.co.uk
W e b
Original Language Version
lS450H issue:1 - 18/04/13
© Jack Sealey limited
WARNING!
the foot pedal is under tension. Before removing the safety clip, put your hand on the pedal to prevent it flying up and
injuring you.
3.1
to assemble
,
ensure that the adjustment screw is wound all the way in, and is touching the back of the splitter head. Remove the
safety clip and fit the foot assembly. Refit the safety clip and hook it over the foot pedal. the log splitter is now ready to use.
3.2 Adjusting working height
3.2.1. Remove the safety clip and adjust the foot pedal height to at least 33cm (13 inches) by screwing the adjustment screw out (to raise the
foot pedal) and in (to lower the foot pedal.)
3.3 Splitting Logs (Refer to Fig. 2)
Tips
Wet or non seasoned wood is more difficult to split than dry wood because the fibres stick together.
Reversing the log and splitting it from the other end may help if you cannot pull the wood apart.
large or multiple knots in a log make splitting more difficult. usually if the log is rotated so the knots are vertical to the blade, the wood
will split more easily and less stress is placed on the splitter. this will reduce wear and tear and the possibility of damaging
components of the splitter.
3.3.1. Remove the safety cover from the cutter. Select your log and lift the slide stop lever to allow it to be moved along the bar. lay the
log on the splitter and push the slide stop onto the end of the log.
3.3.2. Pump the foot pedal down, it may take three or four pumps, until the log is split.
3.3.3. to remove a log from the splitter, that has not been split all the way through, lift the lever on the slide stop and pull it back, place your
foot on the bottom bar and pull the end of the log sideways towards you.
3.3.4. When finished fit the safety cover and safety clip, wind in the adjustment screw and store in a safe, childproof location.
3.3.5. Keep moving parts lubricated with anti-rust machine oil.
3. OPERATION
fig.2
Parts support is available for this product. to obtain a listing and/or diagram, please log on to: www.sealey.co.uk,
email: sales@sealey.co.uk or phone: 01284 757500
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
