3. Hook the ‘S’ plate over the pins on the die carrier.
Screw the adaptor up to the brake pipe, allowing it
to centre in the pipe.
4. Rotate the handle to a suitable position.
5. Close the release valve tightly, then pump the lever
until it goes solid
6. Open the release valve and disengage the ‘S’ plate
to separate the die carrier and ram.
1. Insert brake pipe into the relevant die block, making
sure that the end of the pipe is flush with the end of the
die block. Tighten the bolt with hex key.
2. Pull back the adaptor holder collar and insert the
correct adaptor. Release the collar. Wind the ‘S’ plate back to
provide clearance between the pipe and
adaptor.
5. OPERATION
PFT15 Issue: 1 - 03/11/16
Original Language Version
© Jack Sealey Limited
