INSTRUCTIONS FOR:
POWER INVERTER 12V/230V
MODEL No:
PI300.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained,
give you years of trouble free performance.
IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO
SO MAY CAUSE DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
2. INTRODUCTION & SPECIFICATIONS
2.1 Introduction.
Supplies continuous smooth 230V power from 12V DC power supply found in cars, caravans, boats and HGVs. Suitable for
powering small TVs, laptops, power tools and various other electrical equipment within the wattage rating of the inverter. Features
USB port for use on various domestic electrical equipment such as digital cameras and mobile phones. Anodized aluminium case
provides durability and maximum heat dissipation. Safety features include automatic overload shut-down and a low battery alarm to
prevent damage to the supply battery. Supplied with battery clips and vehicle accessory plug.
1. SAFETY INSTRUCTIONS
Original Language Version
PI300.V3 Issue:1 - 31/03/11
DANGER! - Beware, lead-acid batteries generate explosive gases during normal battery operation.
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush immediately with cool
clean running water for at least 15 minutes and seek immediate medical attention.
DO NOT
smoke or allow a spark or flame in the vicinity of the battery or engine.
If the battery terminals are corroded or dirty, clean them before attaching the clips.
WARNING!
To prevent the risk of sparking, short circuit and possible explosion
DO NOT
drop metal tools in the battery area,
or allow them to touch the battery terminals.
Before attaching to battery, remove personal metallic items such as rings, bracelets, necklaces and watches. A lead acid
battery can produce a short-circuit current which is high enough to weld such items to the vehicle and cause severe burns.
Keep children and unauthorised persons away from the working area.
WARNING! DO NOT
use on any vehicles other than those with 12Volt DC systems.
WARNING!
For delicate items such as laptops, an anti-surge device is recommended.
DO NOT
connect to any AC power source.
DO NOT
disassemble. The inverter must be checked by qualified service personnel only.
DO NOT
get inverter wet or use in damp or wet locations or areas where there is condensation.
DO NOT
use the inverter for any purpose other than for which it is designed.
DO NOT
pull the cables or clips from the battery terminals.
DO NOT
operate the inverter if damaged.
DO NOT
connect to a positive earthed system. Ensure you have the polarity correct before connecting, red clip to positive (+)
battery terminal and black clip to negative (-) battery terminal.
Before connecting ensure nothing is plugged into the inverter, and the inverter is switched OFF.
WARNING! Inverters become hot during use.
When not in use store inverter in a safe, dry, childproof location.
