GSS150819SD Issue: 1 - 20/08/12
© Jack Sealey Limited
Original Language Version
7.3 ASSEMbLE THE FRONT WALL PANELS
7.3.1 Place panel 9A and 9S on your work table and join them together with the 10mm long self tapping screws.
See the pre-punched holes and both diagrams.
7.3.2 Fit top and bottom channels 20B and 20C to panels by firstly sliding and finally tapping into place. Note that
the smaller flange on the channels should always be adjacent to the outside face of the panel. The outside
face is the diagram. Fix both with 10mm long self tapping screws except for positions marked with asterisk *,
which are not fixed at this stage.
*
*
*
*
