5.2.4.
Holding the handle grip (#5) unlock the locking knob (#18) by turning counter clockwise (
fi
g 2) and lower the PC board (#1) fully
down.
5.2.5.
Lock the PC board (#1) into place by turning the locking knob (#18) clockwise (
fi
g 2).
DO NOT
over tighten.
5.2.6.
When the press operation is complete raise the PC board (#1). See section 5.2.1.
5.2.7.
Remove the workpiece.
5.2.8.
Lower the PC board (#1). See section 5.2.4.
5.2.9.
Lock the PC board (#1) See section 5.2.5.
5.3.
REMOVING THE SAFETY GUARD
5.4. NOTE:
Ensure that the PC board (#1) is locked in place and is at it’s lowest position.
5.4.1.
Remove the safety guard by taking hold of the side grips (#10) and raise slightly.
5.4.2.
Align the T shaped screws (#9) with the larger hole of the key slot and pull the safety guard away and place in a secure location.
6. MAINTENANCE
6.1.
Clean with a damp cloth.
DO NOT
use solvents.
PPFSG1, PPFSG2 Issue 1 23/03/22
Original Language Version
© Jack Sealey Limited
fi
g.1
fi
g.2
fi
g.3
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 24 months from purchase date, proof of which is required for any claim.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
