hole or over the wheel stud (fig.1)
4.4.
Install the required adaptor peg to the vehicle wheel hub. The adaptor peg should be fitted to the uppermost position, and if
possible, the hub should be rotated so this is at the 12 o’clock position (fig.2).
4.5.
Position the wheel so it is in front of the vehicle hub by approximately 10 cm / 4”.
4.6.
Insert the lever through the uppermost hole in the wheel and upwards to engage with the adaptor peg.
4.7.
Whilst continuing to push the lever into the wheel hub, use one hand to start lifting the lever up to raise the wheel.
Use the other hand to steady the top of the wheel. As the lever is raised the wheel will slide into position Use one hand to push the
top of the wheel if necessary
4.8.
With the wheel in position, keep one hand on the wheel and withdraw the lever. Ensure the wheel is pushed fully back and then fit 2
of the wheel nuts / bolts finger tight.
4.9.
Remove the adaptor peg and then re-fit all wheel nuts / bolts following the vehicle manufacturers guide-lines.
5. MAINTENANCE
5.1.
Ensure the equipment is in good order and condition.
5.2.
Owing to the potential hazards associated with this tool, do not misuse, or make any modification to any components.
5.3.
It is the responsibility of the tool owner to ensure the operator has read these instructions, and that the operator is familiar with its
use and limitations.
5.4.
Remove any oil or grease from all components before use / storage.
P
egs for BOLT fixings
AK7500 Issue 1 20/05/22
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component
parts without prior notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. Please email sales@sealey.co.uk or telephone 01284 757500
REGISTER YOUR
PURCHASE HERE
12 o’clock position
fig.1
fig.2
S
ee Operation Sections 4.3, 4.4, 4.5
S
ee Operation Sections 4.6, 4.7
