RE23RS | Issue 3 (U) 09/03/20
Original Language Version
© Jack Sealey Limited
CONTENTS
Item no
Description
Qty
1
Pillar adaptor bar
1
2
Pivot spindle
1
3
Plain washer M12 dia
2
4
Hexagon stiff nut M12
2
5
Side restraint hoop right hand
1
6
Side restraint hoop left hand
1
7
Inner restraint hoop
1
8
Intermediate restraint hoop
1
9
Intermediate restraint hoop
1
10
Outer restraint hoop
1
11
Pinch knob M8 X 16
1
12
Pin
1
13
R clip
1
4. ASSEMBLY
4.1.
Empty contents of packaging and display on a bench top to identify and check for missing or damaged parts.
In the unlikely event of missing or damaged parts, consult your Sealey Stockist immediately.
4.2.
SEQUENCE OF ASSEMBLY
WARNING!
Ensure there is not a spring under load on the Compressing Station before assembling.
4.3.
NOTE:
All instructions are while looking at the front of the Compressing Station (the side with yokes on).
4.4.
Slide the pillar adaptor bar (Item 1) over the main pillar of the coil spring compressing station (Models RE231, RE2311 or RE232 -
not included) with the pinch knob facing the same direction as the yokes. (front) (fig.1). Secure in place by sliding the pin (Item 12)
through the appropriate hole from left to right on the main beam and insert the ‘R’ clip (Item 13) through the pin to secure (fig.1).
NOTE:
Height is determined by the size of the spring. Adjust when ready to use. Tighten the pinch knob.
4.5.
Insert the pivot spindle (Item 2) through the pillar adaptor bar (Item 1) with both ends protruding evenly (fig.1).
4.6.
Place the right hand restraint hoop (Item 5) (with the larger boss) onto the right hand side of the spindle with the lug facing the centre
and set the lug behind the fixed lug on the pillar adaptor bar (fig.2). Place the left hand restraint hoop (Item 6) on the left hand side
with the lug facing inwards and set behind the fixed lug on the pillar adaptor bar, as shown in (fig.2).
4.7. NOTE:
(Item 5) has a larger boss than (Item 6) therefore the positioning is important!
fig.1
fig.2