4.8.
Place (Item 7) with the lugs on the right hand side, over both ends of the pivot spindle with the lugs set behind fixed lug. (fig.3).
4.9. NOTE:
(Items 8-10) have side lugs, which are all positioned on the underside, they lift each hoop in turn when cage is lifted up.
4.10.
Place (item 8) with the lug on the right hand side, below (Item 7) and slide each end over the pivot spindle with lug set behind the lug
on (Item 7). Repeat with (Items 9 & 10) (fig.4, 5 & 6).
4.11.
Place washer (item 3) at each end of spindle and wind on hexagon stiff nuts (item 4) with equal engagement, without clamping the
assembly. All loops to pivot freely under their own weight, limited only by the lugs, the right hand side hoop has limited movement.
4.12.
The left hand side hoop rotates fully to allow access to the pins in the main pillar. (fig.9 & 10).
WARNING!
Always fit the restraining chains around the spring (fig.10)
WARNING!
Spring compression station should be securely bolted to the workshop floor before use.
RE23RS | Issue 3 (U) 09/03/20
Original Language Version
© Jack Sealey Limited
fig.8
fig.3
fig.4
fig.5
fig.6
fig.7
fig.9
fig.10
