Ensure you read, understand and follow the safety instructions in Section 1.
4.1.
Attach the retaining spring by screwing it onto the cylinder.
4.2.
Insert the chisel using the hooked end of the spring to hold the chisel in place.
4.3.
Attached the tool to the air supply (see Section 2).
4.4.
To operate the hammer, squeeze the trigger. The air regulator may be used as a means of throttle control.
WARNING!
Disconnect the hammer from the air supply before changing chisels, servicing or performing any maintenance.
5.1.
Keep the hammer oiled for optimum performance.
Lubricate with a good grade of air tool oil such as Sealey ATo/500 or ATo/1000.
If there is no oiler in the air system then a teaspoon of oil can be poured into the air inlet of the hammer, or into the hose at the nearest
connection to the air supply. Then run the hammer for a short time.
Note:
The following external factors may cause loss of power and effect hammer performance:
The air supply.
Reduced compressor output, excessive drain on the air line, moisture or restrictions in air pipes or the use of hose connectors
having too small a bore. Correct as necessary.
The hammer.
Grit or gum deposits in the tool. Correct by cleaning the air strainer and flushing out the tool with gum solvent oil or an
equal mixture of SAE no.10 oil and kerosene. If, despite taking action as above, the tool function is still impaired, contact your local
Sealey service agent.
4. OPERATING INSTRUCTIONS
5. MAINTENANCE
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
no liability is accepted for incorrect use of product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address,
including postcode.
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
Web
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
© Jack Sealey Limited
SA12/S.V3 Issue:1-02/10/13
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to:
www.sealey.co.uk, email: sales@sealey.co.uk or phone:01284 757500.
