Risk of Hand Arm Vibration Injury.
The SBS35 Belt Sander, when operated in accordance with these instructions and tested in accordance with EN 28662-1: 1993
results in the following vibration emission declared in accordance with BS EN12096: 1996.
Measured vibration emission value: ....................... 3.8m/s²
Uncertainty: ........................................... 0.16m/s²
These values are suitable for comparison with emission levels of other tools that have been subject to the same test.
This tool may cause hand-arm vibration syndrome if its use is inadequately managed.
Recommended Measures to reduce risk of hand-arm vibration syndrome:
This item represents a low Hand Arm Vibration risk
to users. The calculated maximum usage period exceeds 8 hours. We recommend appropriate safety equipment is utilised and
regular breaks for the operator are employed to reduce any residual risk of fatigue or repetitive strain injury.
2. INTRODUCTION & SPECIFICATION
3.1
Attach one of the three assorted arms (fig.1), do this by taking the spring provided and placing it into
the circular recess on the grinders fixed arm.
3.2
Fit the arm as in fig.2, insert and tighten the thumb screw (fig.2C) through the arm and adjust as
necessary to make a straight fit.
3.3
Push the arm retraction lever (fig.2B, fig.3D) forward, this will shorten the length of the arm to make it
easier to apply a sanding belt, pull the lever back to tighten the belt.
3.4
Attach the dust collector to the exhaust (fig.3C) squeeze the two metal hooks together, this will enlarge
the rim of the dust bag to fit over the exhaust.
3. PREPARING FOR USE
Specification
Belt .....................6mm x 456mm, 12mm x 456mm
Motor Power ................................................. 400W
Supply.....................................................230V - 5A
No Load Speed ..............................900 - 1400rpm
Weight .........................................................1.45kg
Noise pressure level ................................. 82dB(A)
Noise power level ..................................... 93dB(A)
Vibration level .............................................3.8m/s²
Ideal for use in Bodyshops, sanding otherwise inaccessible areas, such as around door shuts. Features three
different sanding arms to suit the working area. Self-contained dust collection bag to fit exhaust. Six speed
power control. Belt tension release lever for simple removal/replacement. Supplied in tough storage/carry case
SBS35
Issue No: 1 - 21/04/08
fig.1
fig.2
Summary of Contents for SBS35
Page 5: ......
