AIR OPERATED UNDER BODY COATING GUN
model no:
SG139.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Familiarise yourself with the application, limitations and potential hazards peculiar to the coating gun.
WARNING!
disconnect the gun from the air supply before changing accessories, servicing or performing any maintenance.
9
maintain the
gun in good condition (use an authorised service agent).
9
Replace or repair damaged parts.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the gun clean for best and safest performance.
9
ensure that the compressed air system can supply the gun air consumption (10cfm).
9
Wear approved safety respiratory protection and safety eye goggles.
9
Remove ill-fitting clothing. Remove ties, watches, rings and other loose jewellery and tie back long hair.
9
locate the gun in a suitable work area. Keep area clean and tidy and free from unrelated materials and ensure that there is adequate
ventilation and lighting.
9
Keep children and unauthorised persons away from the work area.
9
When not in use, ensure that the air supply is turned off.
9
Avoid unintentional operation of the gun.
8
DO NOT
point the gun at yourself, other persons or animals.
8
DO NOT
direct air from the air hose at yourself, other persons or animals.
8
DO NOT
carry the gun by the hose, or yank the hose from the air supply.
8
DO NOT
use the gun for any purpose other than that for which it is designed.
8
DO NOT
allow untrained persons to operate the gun.
8
DO NOT
get the gun wet or use in damp or wet locations or in areas where there is condensation.
8
DO NOT
operate the gun if any parts are missing or damaged as this may cause failure and/or personal injury.
9
When not in use, disconnect the gun from the air supply, clean thoroughly and store safely.
2. INTRODUCTION
Accepts most types of 1ltr coating tins.
3. SPECIFICATION
model no: ...............................................................SG139.V2
Recommended air pressure: ......................................... 90psi
Air consumption: .......................................................... 10cfm
Air inlet size:..............................................................1/4”BSP
4. PARTS lIST
SG139.V2 |Issue:4 (H,F) 09/03/18
Original Language Version
© Jack Sealey limited
Refer to
instruction
manual
Wear eye
protection
Wear
protective
gloves
Wear
a mask
Wear
protective
clothing
Item
Part No.
Description
Item
Part No.
Description
1 SG139.V2-01 Suction
Tube 8 SG139.V2-08 Packing
2 SG139.V2-02 nozzle
9 SG139.V2-09 Valve
Spindle
3 SG139.V2-03 Screw
Cap 10 SG139.V2-10 o-Ring
4
SG139.V2-04
nozzle
11
SG139.V2-11
Air Valve Spring
5
SG139.V2-05
Gun Body
12
SG139.V2-12
Packing Screw
6
SG139.V2-06
Trigger Stud
13
SG139.V2-13
Air Screw
7 SG139.V2-07 Stop
Ring
14 SG139.V2-14 Trigger
