1.
SAFETY INSTRUCTIONS
2.
INTRODUCTION & SPECIFICATION
3.
ASSEMBLY
!
DO NOT
use the ladder rack clamps if any parts are missing or damaged as this may cause failure and/or personal injury.
"
WARNING!
Due to the variety in design of vehicles and roof bars/racks, it is the user’s full responsibility to ensure no damage occurs
whilst using these ladder rack clamps. Correct attachment of clamps to a vehicle is therefore critical and is beyond control of the
manufacturer,
distributor, or supplier.
"
WARNING!
The user must secure the clamps and any ladders properly, checking the security frequently when in use.
$
WARNING!
Remove any loose objects from the ladders.
$
WARNING!
Avoid any protrusions beyond the side of the vehicle as these may present a risk of injury to passers-by.
!
DO NOT
use the ladder rack clamps for any purpose other than that for which they are designed.
%
DO NOT
secure any other items using the clamps. These are designed for ladders only.
$
WARNING!
Drive carefully - reduce speed accordingly when transporting ladders.
&
Before every use check the clamps for security of fittings or any sign of wear and tear. Replace any worn or damaged parts.
&
Check the ladders are stable before transit.
$
WARNING!
Be wary of the ladder protruding from the boundaries of the vehicle.
$
WARNING
!
Remember the driver of the vehicle is responsible for the security and safety of the load carried.
$
WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
INSTRUCTIONS FOR:
LADDER RACK CLAMPS
MODEL:
SLC2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT
:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND
CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
Safe and easy way to secure ladders with a universal fitment for roof racks. Yellow phosphate finish for added corrosion resistance. Suitable
for trades where ladders need to be transported safely for on-site applications. Supplied with two heavy-duty iron padlocks for security. Made
in Britain and BS1706 approved.
Maximum ladder width:
365mm.
3.1
Assembly.
3.1.1
Pre-assemble both of the ladder rack clamps as in fig.1 above.
ROOF BAR HOOK
LADDER STOP
LADDER STOP
CLAMP BAR
WASHER
LOCK BAR
THREAD
PROTECTOR
fig.1
