Use correct blades. Do not use blades with incorrect size holes. Never use blade washers or bolts that are defective or incorrect.
Refer to unit speci
fi
cation for maximum blade capacity etc.
Inspect and remove all nails from timber before cutting.
Never touch the blade or moving parts during use.
Never start the saw when the blade is in contact with the workpiece.
Keep handles and grasping surfaces dry, clean and free from oil and grease.
LASER LIGHT. LASER RADIATION DO NOT
stare into beam. Only turn laser beam on when tool is on work piece.
2. INTRODUCTION
Powerful 2000W motor. Features integral aluminium workpiece supports which store inside the aluminium base to save space and prevent
loss. Fitted with a 40-tooth TCT blade for fresh wood. Can be
fi
tted with Model No. SMS255B multipurpose blade for use with mild steel,
aluminium and wood with nails. Features double slides which can be locked at di
ff
erent lengths allowing greater control over the desired length
of cut. Max cut of up to 315mm at 0° bevel. Unit is also
fi
tted with a laser guide to help produce accurate cuts. Supplied with workpiece clamp,
dust extraction bag and
fi
tted with carry handle. Features locking increments at mitre stops 0°,15°, 22.5°, 30°, 45° Left & Right.
3. SPECIFICATION
Model no ............................................................. SMS255.V3
Blade size ...................................Ø254 x 2.8 x Ø30mm (40T)
Consumable Parts: ............................................. ...SMS255B
Multipurpose Cut-O
ff
Saw Blade Ø250 x 2.4mm/Ø30mm 60tpu
Dust extraction port ........................ Ø35mm ID x Ø43mm OD
Motor power ................................................................2000W
No-load speed .......................................................... 5000rpm
Positive mitre lock ............0°,15°, 22.5°, 30°, 45° Left & Right
Supply ............................................................................230V
Cross Cut (0
0
Bevel x 0
0
Table) .......................... 90 x 315mm
Mitre Cut (0° Bevel x 45° Table): ........................ 90 x 215mm
Bevel Cut (45° Bevel x 45° Table): ..................... 40 x 215mm
4. COMPONENTS
SMS255.V3 Issue 1 21/05/21
Original Language Version
© Jack Sealey Limited
fi
g.1
fi
g.2
1
Handle
11
Turn table locking handle
19
Bevel pointer
29
Flange bolt
2
ON/OFF Switch
12
Pointer
20
Locking screw for drag guide
30
Outer
fl
ange
3
Lock-o
ff
lever
13
Mitre scale
21
Drag guide
31
Spindle lock button
4
Machine head
14
Turn table
22
Locking screw knob
32
Inner
fl
ange
5
Moving blade guard
15
Fixed saw table
23
Fastening bolt
33
Laser
6
Saw blade
16
Stop rail
24
Screw for cutting depth limiter
34
ON/OFF switch for laser
7
Clamping device
16a
Extension block
25
Stop for cutting depth limiter
35
Laser compartment
8
Workpiece support
16b
Set screw
26
Locking bolt
36
Laser holder
9
Locking screw for workpiece support
17
Sawdust bag
27
Support foot
37
Guide bar
10
Table insert
18
Bevel scale
28
Turn table release lever
38
Adjusting screw
