Sealey SSC11003, Instructions Manual

InstructIons for:

SCREW COMPRESSOR 100ltr 3hp

230V LOW NOISE

moDEL no: 

SSC11003

thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions 

and properly maintained, give you years of trouble free performance.

IMPORTANT:

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND 

CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY 

CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

  1.  SAFETY INSTRUCTIONS

1.1.5.  regularly inspect power supply, leads, plugs and all electrical  

connections for wear and damage, especially power   

connections, to ensure that none are loose. 

1.1.6. 

Important:

the mains voltage must correspond with that  

indicated on the electrical data nameplate.  

1.1.7. 

DO NOT

 pull the powered appliance by the power cable. 

1.1.8. 

DO NOT

 pull power plugs from sockets by the power cable.

1.1.9. 

DO NOT

 use worn or damage leads, plugs or connections.  

Immediately replace or have repaired by a qualified electrician. 

1.1.10. Products which require more than 13amps are supplied  

without a plug. In this case you must contact a qualified  

electrician to ensure that a suitably rated supply is available.  

We recommend that you discuss the installation of an  

industrial round pin plug and socket with your electrician.

 Original Language Version

1.1.   ELECTRICAL SAFETY 

 

Make sure the power supply cable is correctly connected  

to the earth. It is the user’s responsibility to read,  

understand and comply with the following: 

You must check all electrical equipment and appliances to  

ensure they are safe before using. You must inspect power  

supply leads, plugs and all electrical connections for wear  

and damage. You must ensure the risk of electric shock is  

minimised by the installation of appropriate safety devices.  

An rccB (residual current circuit Breaker) should be  

incorporated in the main distribution board.  

You must

 also read and understand the following instructions  

concerning electrical safety. 

1.1.1. the 

Electricity At Work Act 1989

 requires all portable  

electrical appliances, if used on business premises, to be  

tested by a qualified electrician, using a Portable Appliance  

tester (PAt), at least once a year.

1.1.2. the 

Health & Safety at Work Act 1974

 makes owners of  

electrical appliances responsible for the safe condition of the  

 appliance 

and the safety of the appliance operator. 

If in any  

doubt about electrical safety, contact a qualified   

 electrician.

1.1.3.  Ensure insulation on all cables and the product itself is safe  

before connecting to mains power supply. 

1.1.4.  Ensure that cables are always protected against short circuit  

and overload.

SSC11003

1.1.11. If it is necessary to replace a plug on the power supply cable  

ensure that the earth wire is connected. All electrical repairs  

must be carried out exclusively by a qualified electrical  

engineer. Avoid all risks of electric shocks. never use the  

compressor with a damaged electrical mains supply cable.  

regularly check all electrical cables. never use the    

compressor in or near water or near a hazardous area where  

electrical shocks may be encountered.

1.1.12. use only extension cables with a plug and earth connections.

the use of too thin an extension cable would result in a  

voltage drop and consequent overheating. An extension cable  

with a cross-sectional area of 6mm² is recommended.

ssc11003   Issue: 1 - 03/05/13

© Jack sealey Limited