3.6
SETTING MAxIMUM TORQUE VALUE
3.7
PEAK HOLD / TRACK MODE SELECTION
Increase Max. Torque Value
Press
Decrease Max. Torque Value
Note: If the display shows the wrench has had a torque
of more than 110% of the maximum specification applied.
Set Peak/Track mode
Press for Selection
Set Peak/Track mode
Press
Press
Pre-setting Torque Value
Press
Long Press
Peak Hold Mode
Communication
*Note 1
Communication
Note:
Communication is for calibration of torque wrench. Please
contact your Sealey dealer for more information.
(Exit)
3.8
TRACK MODE OPERATION
Note:
If the display shows the wrench has had a torque
1.
of more than 110% of the maximum specification applied.
The green LED will be on for 90% of maximum setting
2.
torque.
The red LED will be on 100% of maximum setting torque.
3.
Apply Torque
Current Torque Value
Over 90% of Max. Target Value
Current Torque Value
Green LED
Over 90% of Set Torque
Buzzer
*Note 2
Over Max. Target Value
Red LED
Over Max. Set Torque
((…((… …))…)) ((…((… …)) …))
(((((((( )))))))) (((((((( ))))))))
*Note 3
Buzzer
START
(System initial)
*Note 1
Max. Target Value
n n n
n n n
STW298 Issue No: 1 - 02/06/09
