4. OpERATION
4.1.
Select the appropriate removal socket to create a tight fit over the wheel nut.
4.2.
Fit the socket over the wheel nut and insert the punch (fig.1).
4.3.
Using a suitable hammer, strike the punch sharply several times until the socket has gripped the wheel nut.
4.4.
Place either a wrench or impact socket over the hex at the rear of the removal socket.
4.5.
Release the wheel nut by turning as a unit with the removal socket.
4.6.
Hold the removal socket in a vice and pass the drift through the rear end of the socket and strike the drift to release the wheel nut
(fig.2).
WARNING:
Take care when removing the nut from the removal socket: the nut can exit the socket with
considerable force.
5. MAINTENANCE
5.1.
Clean the inside of the socket with abrasive paper or cloth to remove any dirt or irregularity.
5.2.
Keep the kit clean and store all the components in the case after use.
Sealey Group, Kempson Way, Suffolk Business park, Bury St Edmunds, Suffolk. Ip32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
ENVIRONMENT pROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
fig.1
fig.2
SX272.V2 Issue 1 22/05/18
Original Language Version
© Jack Sealey limited
