7.3.
horizontal gap: adjust the horizontal arm lock plate
7.3.1.
isolate the air supply and remove protective cover at the upper end of the horizontal arm. using a spanner to loosen the lock cap on
the M6 screw at the 2 ends. Adjust the M6 screw at two ends fig.33.3 meanwhile push the horizontal shaft until it moves smoothly.
Then tighten the nut. Use the spanner to adjust the screw in the middle fig.33.4. Tighten the horizontal arm and observe the gap.
When the gap is 2mm, lock the nut.
fig.33
fig.32
tc10 | issue 1 02/02/18
Original Language Version
© Jack sealey limited
Sealey group, Kempson Way, Suffolk business Park, bury St edmunds, Suffolk. iP32 7ar
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
note
: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
environment Protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Weee regulationS
dispose of this product at the end of its working life in compliance with the eu directive on Waste electrical and electronic equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. contact your local solid
waste authority for recycling information.
