background image

01284 757500

01284 703534

sales@sealey.co.uk

Sole UK Distributor, Sealey Group, 

Kempson Way, Suffolk Business Park

Bury St. Edmunds, Suffolk,

IP32 7AR

www.sealey.co.uk

Environmental Protection

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, 

taken to a recycling centre and disposed of in a manner which is compatible with the environment.

When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable) into 

approved containers and dispose of the product and the fluids according to local regulations.

WEEE Regulations

Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and 

Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally 

protective way. Contact your local solid waste authority for recycling information.

Parts support is available for this product. To obtain a parts listing and/or diagram, 

please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.

NOTE:

 It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without 

prior notice.

IMPORTANT: 

No liability is accepted for incorrect use of this product. 

WARRANTY: 

Guarantee is 12 months from purchase date, proof of which will be required for any claim. 

© Jack Sealey Limited

    Original Language Version 

    TIG160S.V2,  TIG180S.V2, TIG200S.V2     Issue: 1 - 11/07/16

Summary of Contents for TIG160S.V2

Page 1: ...er plugs from sockets by the power cable 1 1 9 DO NOT use worn or damage leads plugs or connections Replace or have repaired immediately by competent persons In case of damage cut off and fit a new plug 1 1 10 NO plug is fitted to this machine Whilst it is possible to perform TIG welding at lower power settings using a 13Amp mains source ordinary ARC welding without gas and TIG welding at higher p...

Page 2: ...or strain cables protect from sharp or abrasive items and DO NOT stand on cables or leads Protect from heat Long lengths of slack must be gathered neatly coiled DO NOT place cables where they may cause a hazard DO NOT touch the workpiece close to the weld as it will be very hot Allow to cool DO NOT touch the torch immediately after use Allow the torch to cool DO NOT operate inverter while under th...

Page 3: ...fig 2 2 4 6 2 The pre flow time fig 2 A pulse peak current fig 2 D pulse width fig 2 F pulse frequency fig 2 G pulse background current fig 2 G and gas delay time fig 2 J may all be adjusted in this mode 4 6 3 To select the parameter press the parameter setting control to cycle between functions The value may be adjusted by rotating the setting control fig 2 5 4 7 STATUS WARNING LIGHTS 4 7 1 Power...

Page 4: ...of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment WEEE When the product is no longer required it must be disposed of in an environmentally protective way Contact your local solid waste authority for recycling information Parts support is available for this product To obtain a parts listing and or diagram please log on to www sealey co uk email sal...

Reviews: