background image

 

 

this symbol indicates that a device is protected throughout by double insulation or reinforced insulation.

 

‰

  

Warning! 

 

NEVER apply voltage or current to the multimeter that exceeds the specified maximum as shown below:

input limits

function

maximum input

V Ac

600V dc/Ac

V dc or V Ac

600V dc/Ac,200V rms on 200mV range

  mA dc

200mA 250V fast acting fuse

A dc

10A 250V fast acting fuse (30 seconds max every 15 min.

resistance, continuity

250V rms for 15sec max

1.4.    

BAtterY instAllAtion

 

‰

  

Warning!

  to avoid electric shock, disconnect the test leads from any source of voltage

  

 

before removing the battery cover.

 

 

disconnect the test leads from the meter.

 

 

open the battery cover by loosening the two screws using a Phillips head screwdriver. 

 

 

remove old battery (if applicable) and insert the new battery into battery holder, observing 

 

 

the correct polarity. fit the battery cover back in place. secure it with the screws.

 

‰

  

Warning!

 to avoid electric shock, do not operate the meter until the battery cover is in

  

place and fastened securely.

  

note!

 if your meter does not work properly, check the fuses and battery to make sure that

  

 

they are still good and that they are properly inserted.

2.  introduction

High precision multimeter. conforms with en61010-1 cAtiii 600V safety requirements for 

electrical equipment for measurement, 

control, and laboratory use. features non-contact Ac voltage detection function.

double moulded housing with soft grip case and large display for ease of use. the housing

has practical storage for probes and lead and has an integral upright stand for use on the 

workbench. measures:

 

 

• AC and DC Voltage

 

 

• DC Current

 

 

• Resistance

 

 

• Diode Test

 

 

• Continuity Buzzer

 

 

• Non Contact Voltage Detection (NCVD)

  

1.   lcd display

   

2.   function switch

   

3.   10A Jack 

   

4.   com Jack

   

5.   Positive Jack

   

6.   non contact Voltage (ncV) Warning light

 

sYmBols And AnnunciAtors

 

 

•))) 

Continuity Test

 

 

 

diode test

 

 

µ 

micro (Amps)

 

 

milli (Volts, Amps)

 

 

Kilo (ohms)

 

 

Ω 

Ohms

 

 

Vdc 

Volts direct current

 

 

VAc 

Volts Alternating current

 

 

Adc 

Amps direct current

 

 

BAt  

Battery test

tm101 | issue 3 12/10/16

Original Language Version

© Jack sealey limited

 

REMOVE SCREWS 

TO ACCESS 

BATTERY AND 

FUSES

1

6

2

3

4

5

Reviews: