5. maintenance
5.1.
rePlAcinG tHe BAtterY
Warning!
to avoid electric shock, disconnect the test leads from any source of voltage before removing the battery cover.
5.1.1.
When the battery becomes exhausted or drop below the operating voltage, “BAt” will appear in the right-hand side of the
lcd display. the battery should be replaced.
5.1.2.
follow instructions for installing battery. see the Battery installation section of this manual (1.4.).
5.1.3.
dispose of the old battery properly - see recycling statements at the end of this manual.
Warning!
to avoid electric shock, do not operate the meter until the battery cover is in place and fastened securely.
5.2.
rePlAcinG tHe fuses
Warning!
to avoid electric shock, disconnect the test leads from any source of voltage before removing the fuse cover.
5.2.1.
disconnect the test leads from the meter and any item under test.
5.2.2.
open the fuse cover by loosening the screw on the cover using a Phillips head screwdriver.
5.2.3.
remove the old fuse from its holder by gently pulling it out.
5.2.4.
install a new fuse into the holder.
5.2.5.
Always use a fuse of the proper size and value (0.5A/250V fast blow for the 200mA range, 10A/250V fast blow for the 10A range).
5.2.6.
fit the fuse cover back in place. insert the screw and tighten it securely.
Warning!
to avoid electric shock, do not operate the meter until the fuse cover is in place and fastened securely.
Warning!
Before attempting to open the case, ensure that the test leads have been disconnected from the multimeter and that it is
switched off to avoid electric shock hazard.
5.3.
clean the multimeter’s casing using a very slightly dampened cloth and mild detergent - do not use any abrasives or solvents. clean
the inside of each terminal using a swab soaked in isopropyl alcohol, use a new swab to apply a light coat of machine oil to each
terminal.
5.4.
if the multimeter is to be stored for a long period of time, remove the battery first to avoid any damage.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important:
no liability is accepted for incorrect use of this product.
Warranty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
Battery removal
see section 1.4
under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered wih Valpak’s
registered compliance scheme. Jack sealey ltd’s Batteries Producer registration number (BPrn) is BPrn00705.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
