2. IntRoductIon
t
Ratchet type axle stand with cast iron support and tough steel plate welded base. Angled teeth in post prevent accidental release of load - the more
weight applied, the tighter the post is locked. Sold in pairs.
3. sPecIfIcAtIon
Capacity each: ....................................... 2 tonnes (2,000 kg)
Capacity pair: ......................................... 4 tonnes (4,000 kg)
min. height: ................................................................ 261mm
max. height: ............................................................... 415mm
Weight: ........................................................................ 5.58kg
4. AsseMbly
4.1. insert the centre column into the base frame and stand (fig.1).
4.2. ensure the toothed side of column will engage with the locking lever
mechanism (fig.2).
4.3. Bend in locking tab using a drift or similar and a hammer (fig.3).
4.4. Check the base frame and stand is in good condition and has not
suffered damage during transit.
5. oPeRAtIon
5.1. Refer to manufacturer’s instructions for recommended jacking/support points.
5.2. Check to ensure jacking/support points are in good condition. Position the stands beneath their
support points.
5.3. To adjust the stands:
Hold the control lever up while lifting the centre column to required height. Push the control lever
down to lock the pawl into the central column teeth (fig.1 and fig.2).
WARnInG! ensuRe PAWl Is fully enGAGed WIth teeth.
5.4. Carefully and slowly lower vehicle onto stands. ensure load bearing points sit in the centre of the
saddles and that the stands are stable.
5.5. ensure that there are no objects or persons that could impede the safe lowering of the
vehicle onto the stands.
▲
dAnGeR!
You must follow instructions carefully and ensure you
do not
load the stands off
centre. Failure to adhere to these warnings may cause damage, injury or loss of life!
5.6. Store the stands in their lowest position.
6. MAIntenAnce
6.1. Before each use, check that stands and stand welds are not cracked and that there are no missing or damaged parts.
Any suspect axle stands must be removed from service immediately
6.2. due to the potential hazards associated with stands,
do not
misuse, or make any modification to, the stands or components
6.3. it is the responsibility of the owner to ensure that the operator has read these instructions together with the safety features on the
side of the stand and that the operator is aware of the stand uses and limitations.
Original Language Version
© Jack Sealey limited
sealey Group, Kempson Way, suffolk business Park, bury st edmunds, suffolk. IP32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
note
: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
enVIRonMent PRotectIon
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
fig.1
fig.2
fig.3
VS2002.V2 issue: 6(F) - 20/12/18
