tRANSMISSION & ENGINE OIL
FILLING SYStEM
mODEL NO:
VS7009.V2
thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFEtY
WARNING!
Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
equipment.
9
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
9
maintain the product in good condition (use an authorised service agent).
9
Replace or repair damaged parts.
Use genuine parts only. Non authorised parts will invalidate the warranty.
9
Use only to pump oils up to SAE 140 viscosity.
9
Ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
Dispose of waste liquids in accordance with local authority regulations.
8
DO NOt
use to extract corrosive fluids.
8
DO NOt
dismantle, tamper with or adapt the pump for any purpose other than for which it is designed.
8
DO NOt
use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
9
Keep the pump clean and store in a safe, dry, childproof location.
WARNING! DO NOt
allow uncontrolled discharge of fluids thus polluting the environment.
2. INtRODuctION
manually operated oil dispensing unit manufactured from composite materials. Large visual measurement will identify amount dispensed.
Supplied with a range of five automatic transmission fluid adaptors. Delivers approximately 70ml per stroke. Features a fluid control valve and
adaptor stowage to minimize oil leakage when not in use.
3. SpEcIFIcAtION
model no ..............................................................
VS7009.V2
Capacity .............................................................................
7lt
Hose length .................................................................... 1.5m
4. cONtENtS
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
clothing
Item
part no.
Description
1
V
S7009.A01
Adaptor Ford
2
V
S7009.A02
Adaptor universal
3
V
S7009.A05
Adaptor VW Audi
4
V
S7009.A04
Adaptor VW Audi
5
V
S7009.A03
Adaptor VW Audi
Accessories
part no.
Description
V
S70091
T
ransmission oil filler adaptor - VAG M30 x 1.5mm
V
S70092
T
ransmission oil filler adaptor - Toyota/Lexus M18 x 1.5mm
V
S70093
T
ransmission oil filler adaptor - VW Passat/Tiguan
V
S70090
3pc Transmission oil adaptor set
V
S7009.V2 | Issue:1 12/08/19
