INSTRUCTIONS FOR
BMW REAR BALL JOINT TOOL
MODEL NO:
VSE5509.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
8
DO NOT
use the kit if any parts are missing or damaged.
8
DO NOT
use the rear ball joint tool for any purpose other than that for which it is designed.
9
Maintain the tool components in good and clean condition for best and safest performance.
9
Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
9
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
9
Keep children and other unauthorised persons away from the working area.
9
Ensure there is adequate lighting prior to using the ball joint tool.
IMPORTANT:
These instructions are provided as a guide only. Always refer to the vehicle manufacturer’s service instructions, or a
proprietary manual, to establish the current procedure and data.
2.
i
INTRODUCTION
Designed to remove and install press-fit rear suspension ball joints in situ, on BMW 5 and 7 Series. These joints are sometimes referred
to as ‘bushes’ but are true ball joints.
3.
i
CONTENTS
VSE5509.V2 Rear Suspension Ball Joint tool comprises:
Item
Description
Part
No.
1 Force
Screw
VSE5509.V2-01
2 Force
Nut
VSE5509.V2-02
3 Removal
Driver
VSE5509.V2-03
4 Removal
Receiver
VSE5509.V2-04
5 Installation
Driver
VSE5509.V2-05
6
Installation Anchor
VSE5509.V2-06
4. APPLICATIONS
BMW:
5 Series E39
BMW:
7 Series E38
VSE5509.V2 Issue 2 (H,3,F) 23/03/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear protective
gloves
Wear eye
protection
Wear protective
clothing
fig.2
fig.1
