4.1.
Assembling the Stand. See fig.1.
4.1.1. Screw the two uprights to the base, with the bearings facing
inwards, using 8 x hex headed screws and nuts.
4.1.2. Screw the threaded bolts through the uprights and screw a
cone onto each one.
4.1.3. Screw the four feet into the base and use a spirit level to
ensure the stand is level.
4.1.4. Place the cones on to the spindle and place the spindle onto
the bearings.
4.1.5. Slide the truing pointer into its holder and tighten the holding
screw. The pointer can be adjusted up and down by undoing
the nut on the back.
INSTRUCTIONS FOR
MOTORCYCLE & BICYCLE WHEEL
BALANCER & TRUING STAND
MODEL No:
WTS01
Professional design ideal for the workshop technician or competent DIY enthusiast. Enables the accurate balancing after tyre fitting and truing
of warped or buckled spoke wheels. Includes two cones and spindle for precise, easy alignment and balancing. Uses gravity to find the heavy
point of a wheel and tyre. Also has threaded centring stabilizer bolts to securely hold the wheel whilst truing the rim. Truing is done by adjusting
the tension of the spokes.
GENERAL SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
WARNING!
Familiarise yourself with the specific applications and limitations of the tool as well as any potential hazards.
This tool should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer’s manual.
Ensure that the tool is correct for the task.
Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey dealer.
DO NOT
use the tool
for any purpose other than that for which it is designed.
Ensure there is adequate lighting prior to using the tool.
Keep children and unauthorised persons away from the working area.
DO NOT
use the tool if any parts are damaged or missing, as this may cause failure and/or personal injury.
DO NOT
use the tool
when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
After use, store in a safe, dry childproof area.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. SAFETY
2. INTRODUCTION
3. SPECIFICATION
WTS01 Issue: 1 - 25/02/15
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . WTS01
Maximum Cone Size Balancer: . . . . . . . . . . . Ø37.5mm
Centre Balncer Spindle to Base: . . . . . . . . . . . . 585mm
Maximum Cone Size Truing Axle:. . . . . . . . . . . .Ø37mm
Centre Truing Axle to Base: . . . . . . . . . . . . . . . . 445mm
fig.1
