42
VII. Care and Maintenance
1.
After each use, Digital Flash and camera housing must be soaked
in fresh water immediately to
remove salt and dirt. Keep housing
and flash sealed.
2.
Never use any detergents, cleaners,
solvents or chemicals to clean the
flash. The mask bucket on a boat is
full of detergent – do not use this.
3.
Let the water drain out of the flash
arm (which has small drainage holes)
thoroughly before storage. Flash arm
links can be separated to remove
excess water.
4.
Remove all batteries. Make sure flash (and you) are dry before open-
ing compartment door) Insert fresh Moisture-Muncher desiccant
capsules (item # SL911), and hang it up to dry in a well ventilated
place similar to drying your wet suit.