Latest products and information available at www.sealite.com
14
SL-75
3–5NM+ Solar Marine Lantern
The IR remote is used to communicate with Sealite lighting products that have
an IR sensor
fi
tted. The remote control is used for the following functions:
• Flash Code: read the current
fl
ash code, con
fi
gure a new
fl
ash code.
• Lamp Intensity: read the current lamp intensity, con
fi
gure a new intensity
level.
• Ambient Light Thresholds: read the current light thresholds, con
fi
gure new
ambient light thresholds.
• Perform a battery health check.
On receiving a valid key signal from the IR Remote, the light will
fl
ash once.
The user should wait until the light responds to each keypress before pressing
another key. If there is no response to the keypress after 3 seconds, it has not
been detected by the light and the key can be pressed again.
If an invalid key is detected, the light will
fl
ash quickly 5 times. In this case, the
command will have to be restarted.
T/C
T/C
Read
Lux
Flash Code
Intensity
Battery Status
Test / Configure
R
L
FC
I
B
3
4
5
6
7
8
9
0
1
2
Optional IR Remote Control
Sealite IR Controller / Universal Remote Compatibility
If you lose your Sealite IR Controller, the following Universal Remote Controller has been tested for
compatibility: RCA Type RCR312WR programmed for Phillips TV Type Code 10054
Sealite Key
Universal
Remote Key
T
Power
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
0
0
R
L
Mute
FC
I
Volume-
B
Channel-
