11
SQUEEGEE SP300
FILLING MATERIAL TANK:
9.
When cutting material in the machine, always place sealer in the
tank before adding water.
10.
Start the agitator by moving the agitator control valve #H-10
to the forward position. Agitate speed with control speed knob
on agitator motor #H-9. Set agitator to a proper consistent
speed.
11.
To avoid a buildup of sand on the sides of the machine,
always pour sand into the center of the tank. The usual amount
of sand used to provide an anti-skid surface or to fill porous
pavement is three pounds per gallon of sealer. This will vary
according to the porosity of the surface you are sealing.
42
CONTROL
LEVER
H-10
AGITATOR
CONTROL VALVE
7
WATER TOGGLE
SWITCH
H-14
REAR ASSEMBLY
UP AND DOWN
H-15
REAR ASSEMBLY
LEFT AND RIGHT
33
CHOKE
34
THROTTLE
1
IGNITION SWITCH
Summary of Contents for SP 300
Page 1: ......
Page 27: ...25 HYDRAULIC FLOW CHART ...
Page 41: ...39 SQUEEGEE SP300 DUAL SPRAY SANDPUMPER II SANDPUMPER II ...
