47
OPERATION INSTRUCTION
SANDPUMPER II
FILLING THE TANK FROM ANOTHER CONTAINER:
1.
Follow the maintenance procedures listed in the engine manual.
2.
Connect a suction hose to pump in valve #59 and your drum or
tank. Open the valve.
3.
Open recirculation valve #54.
4.
With the engine running, turn on the SandPumper II pump toggle
switch #48. Open the pump speed control valve #53 about three
turns. You should now be hearing clicking from the pump and the
pump pressure gauge #56 will be showing pressure. Material is
now being drawn from the container and is filling up the
machine’s tank.
5.
Monitor the level by looking in through the lid and using your
tank chart as a guide for how much material you want to add.
When done, close pump in valve #59 and pump speed control
valve #53. Turn off pump toggle switch #48. Detach the suction
hose.
6.
Add the desired amount of water, and additives. Engage the
agitator control valve #7 to the desired position. Speed control is
achieved by turning the knob located on the side of the agitator
drive motor #21. Turn clockwise to rotate faster.
SLOWLY
add
your sand in the center of the tank. Let the agitator mix in each
bag before adding another. Let the agitator rotate slowly during
the application process.
Summary of Contents for SP 300
Page 1: ......
Page 27: ...25 HYDRAULIC FLOW CHART ...
Page 41: ...39 SQUEEGEE SP300 DUAL SPRAY SANDPUMPER II SANDPUMPER II ...