- 19 -
refer for the construction book.
b Note 1 This software is for showing the temperature curve and
recorder, the software does not have the motion control functions,
for the movement of the machine need manual adjustment.
c Note 2 The related temperature profiles, you can set through the
meter on the machine. However, in order to facilitate the users for
temperature setting, in particular for the temperature curve showing,
save and print, so we develop and expand this software.
5
、
Click download Controller”
，
so the temperature for just setting
can be down load to the programmable controller.
6
、
Fix the nozzle according to the BGA chip, pay attention to the top
heater work normal or not; if not, stop heating, and check what the
problem is. Otherwise it will damage the heating wire easily as the
high temperature.
7
、
Fix the PCB board on the PCB pallet, and make the heating part
just below the nozzle.
8
、
Adjust Z-axis and Y-axis to make the nozzle on the top of the
heating part, the height between them is 2
～
5mm.(Figure 8)
9
、
Click Run/Stop
，
the machine will carry out heating motion.
10
、
At this time you can see the temperature curve.(Figure 9)
11
、
Curve 1 Green shows The actual measurement of heater
temperature
