PAGE
5
Deflation Operation
If you can use the pump to inflate the chamber, you can use it to deflate the same chamber too.
Attach the yellow hose onto the deflation side of the inflator (round outlet with notches). Attach the other
end to the chamber you wish to deflate.
You don’t have to set any pressure, just press the START button. The turbine fan will work for the
deflation operation. The 2nd stage will never get started since the pressure monitoring feature no function.
When you have most of the air out of the chamber, turn the pump off and disconnect the hose from that
chamber. You must turn off the pump manually since it won't auto stop.
WARNING! NEVER LEAVE THE PUMP UNATTENDED WHEN USING THIS FEATURE AS YOU MAY CAUSE
EXTREME DAMAGE TO YOUR INFLATABLE AND TO THE PUMP
.
Battery & Maintenance (80DB)
About Battery and Charger
:
80DB model has a built-in battery & travel charger. The type of this battery is 12V gel battery, lead acid
type, battery capacity 7AH. The battery will have up to 500 Cycles & up to 8 years battery life time if you
can follow this maintenance manual.
Always keep the pump battery (80DB) full charged before putting at storage or after every use.
The charger is 110/240V travel type with double charging procedures. When you plug in the charge and
connect with the pump, a red light showing on the charger can indicate the battery charging. The max
charging current is 1A from the charger.
After the battery 95% charged, the charger will turn to a battery recovery procedure with a special current.
The light still shows RED and the entire charging period will be up to 72 hours.
When the battery recovery charging done, the charger light will turn green and automatically shut off.
Always take off all the power connection when the battery fully charged. Make sure the pump had been
TURN OFF before storing it. Don't leave the charger on the wall when no using.
Tips: A pump over-night charging should be good enough for your 2nd day using.
