PANEL METER FOR INW PT12 SENSOR
Seametrics • 253.872.0284
Page 12 inwusa.com
Temperature
You cannot change display units for temperature. They will always display in degrees
Celsius. However, if you are using other than PSI for pressure and you later want to
read temperature, you must set the display units per the chart below. Failure to do this
will result in erroneous temperature readings. If you switch back to pressure, you must
reset for pressure units again.
Units
Input 1
Display 1
Input 2
Display 2
Temperature -10.000
-10.000
100.000
100.000
Default - if only using PSI
If you have been using other than PSI for pressure units and wish to return to using
just PSI, then change the display units as shown in this chart.
Units
Input 1
Display 1
Input 2
Display 2
Default -199.999
-199.999
999.999
999.999
Once these defaults have been reset, you can switch between reading pressure and
reading temperature without having to change the display settings.
