background image

PANEL METER FOR INW PT12 SENSOR

Seametrics • 253.872.0284 

Page 17 inwusa.com

The limited warranty set forth below is given by Seametrics, with respect to Seametrics and INW brand products purchased in 

the United States of America.
Seametrics warrants that products manufactured by Seametrics, when delivered to you in new condition in their original 

containers and properly installed, shall be free from defects in material and workmanship. 

Seametrics products are warranted 

against defects for a period of two (2) years from date of installation, with proof of install date. If no proof of install 

date can be provided, warranty period will be two (2) years from date of shipment from Seametrics, as defined on 

Seametrics’ invoice. 

Seametrics’ obligation under this warranty shall be limited to replacing or repairing the part or parts, 

or, at Seametrics’ option, the products, which prove defective in material or workmanship. The following are the terms of 

Seametrics’ limited warranty:

a. 

Buyer must give Seametrics prompt notice of any defect or failure and satisfactory proof thereof.

b. 

Any defective part or parts must be returned to Seametrics’ factory or to an authorized service center for inspection. 

c. 

Buyer will prepay all freight charges to return any products to Seametrics’ factory, or another repair facility. as 

designated by Seametrics.

d. 

Defective products, or parts thereof, which are returned to Seametrics and proved to be defective upon inspection, 

will be repaired to factory specifications.

e. 

Seametrics will deliver repaired products or replacements for defective products to the buyer (ground freight prepaid) 

to the destination provided in the original order. 

f. 

Products returned to Seametrics for which Seametrics provides replacement under this warranty shall become the 

property of Seametrics.

g. 

This limited warranty covers all defects encountered in normal use of Seametrics products, and does not apply to the 

following cases:
i. 

Loss of or damage to Seametrics product due to abuse, mishandling, or improper packaging by buyer

ii. 

Failure to follow operating, maintenance, or environmental instructions prescribed in Seametrics’ instruction 

manual

iii. 

Products not used for their intended purpose

iv. 

Alterations to the product, purposeful or accidental

v. 

Electrical current fluctuations

vi. 

Corrosion due to aggressive materials not approved for your specific product

vii. 

Mishandling, or misapplication of Seametrics products

viii. 

Products or parts that are typically consumed during normal operation

ix. 

Use of parts or supplies (other than those sold by Seametrics) which cause damage to the products, or 

cause abnormally frequent service calls or service problems

h. 

A new warranty period shall not be established for repaired or replaced material, products, or supplied. Such items 

shall remain under warranty only for the remainder of the warranty period on the original materials, products, or 

supplies.

i. 

In the event that equipment is altered or repaired by the buyer without prior written approval by Seametrics, all 

warranties are void. Damage caused by equipment or accessories not manufactured by Seametrics may void the 

product’s warranty.

j. 

SOFTWARE: The Seller grants the user a non-exclusive license to use Seametrics’ software, according to the following 

limitations and conditions:
i. 

The user may install the software on one or more desktop or laptop computers.

ii. 

All title and intellectual rights to the software are owned by Seametrics. 

iii. 

No copies may be made or distributed except as described above. 

iv. 

The user may not modify or reverse-engineer the software.

THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, WHETHER ORAL, WRITTEN, EXPRESSED, IMPLIED OR 

STATUTORY. NO IMPLIED WARRANTY, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A 

PARTICULAR PURPOSE, APPLIED TO THE PRODUCTS AFTER THE APPLICABLE PERIOD OF THE EXPRESS LIMITED WARRANTY 

STATED ABOVE, AND NO OTHER EXPRESS WARRANTY OR GUARANTY, EXCEPT AS MENTIONED ABOVE, GIVEN BY ANY 

PERSON OR ENTITY WITH RESPECT TO THE PRODUCTS, SHALL BIND SEAMETRICS. SEAMETRICS SHALL NOT BE LIABLE FOR 

LOSS OF REVENUES, OR PROFITS, OR INCONVENIENCES, EXPENSE FOR SUBSTITUTE EQUIPMENT OR SERVICE, STORAGE 

CHARGES, LOSS OF DATA, OR ANY OTHER SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGE CAUSED BY THE USE OR 

MISUSE OF, OR INABILITY TO USE THE PRODUCTS, REGARDLESS OF THE LEGAL THEORY ON WHICH THE CLAIM IS BASED, 

AND EVEN IF SEAMETRICS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT SHALL RECOVERY 

OF ANY KIND AGAINST SEAMETRICS BE GREATER IN AMOUNT THAN THE PURCHASE PRICE OF THE PRODUCT SOLD BY 

SEAMETRICS AND CAUSING THE ALLEGED DAMAGE. WITHOUT LIMITING THE FOREGOING, YOU ASSUME ALL RISK OF 

LIABILITY FOR LOSS, DAMAGE, OR INJURY TO YOU AND YOUR PROPERTY AND TO OTHERS AND THEIR PROPERTY ARISING 

OUT OF USE OR MISUSE OF, OR INABILITY TO USE THE PRODUCTS NOT CAUSED DIRECTLY BY THE NEGLIGENCE OF 

SEAMETRICS.
SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATIONS 

MAY NOT APPLY TO YOU. SIMILARLY, SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATIONS OF CONSEQUENTIAL 

DAMAGE, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS LIMITED WARRANTY GIVES YOU 

SPECIFIC LEGAL RIGHTS; HOWEVER, YOU MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE.  

SEAMETRICS LIMITED WARRANTY

Summary of Contents for INW





















Reviews: