1 2
REMOTE CON TROL
NOTE
Batteries installed incorrectly can cause battery
leakage and corrosion that will damage the remote
control
Installing Batteries
Before you can use the remote control, you must install two AA (1.5-volt)
alkaline batteries:
1
Slide open the battery door on the back of the remote control.
2
Insert the batteries in the direction indicated on the inside of the
battery compartment.
3
Slide the battery door closed until it snaps into place.
4
Point the remote control at the DCT 5000, press
CABLE
and then
press
POWER
. If the DCT 5000 does not turn on, check the orientation
of the batteries or replace with new batteries
