2.0
Safety Notes
This PrimeTest 200 has been built and tested in accordance with:
DIN VDE 0404 part 1 and 2.
BS EN 61010 part 1.
BS EN 61557 part 1, 2, 4 and 10.
The PrimeTest 200 has left the factory in a perfectly safe state. To maintain this
state and ensure safe operation of the unit, all notes and warnings in these
instructions must be observed at all times.
This instrument may be used on electric circuits, which comply to
over voltage category II. The PrimeTest 200 monitors the input
voltage and will display a warning symbol. on the display if a 30 V
AC/DC voltage is detected. The symbol warns the operator that a
dangerous voltage is connected to the unit.
The tester and all associated cables and leads must be checked
for signs of damage before the equipment is operated.
Attention! During insulation resistance measurements and Class I
and Class II tests, high voltage levels occur within the
PrimeTest 200.
Do not exceed the maximum permitted voltage of 30 V AC/DC with
respect to earth potential when performing point to point test i.e.
Low resistance measuring function
Ω
and insulation resistance
measurement function M
Ω
! Electric shock danger!
Where safe operation of the tester is no longer possible, it should be
immediately shutdown and secured to prevent accidental operation.
It must be assumed that safe operation is no longer possible:
- if the instrument or the measuring leads show visible signs of damage, or
- the tester does not function, or
- after long periods of storage under adverse environmental conditions.
Important
- Do not touch the bare probe tips of the measuring leads.
- Ensure the measuring leads are plugged into the corresponding
sockets on the PrimeTest 200
i.e.
red lead - red socket - positive
black lead - black socket -negative.
- Do not operate the PrimeTest 200 in an explosive gas or dust
environment.
3.0
Accessories
3.1
Standard Accessories
The PrimeTest 200 is supplied with the following items:
3.1.1 1 off PrimeTest 200
3.1.2 1 off 1.2 M test lead red
3.1.3 1 off 1.2 M test lead black
3.1.4 1 off alligator clip, red
3.1.5 1 off alligator clip, black
3.1.6 1 off IEC mains cord
3.1.7 1 off professional carry case
3.1.8 6 off alkaline batteries 1.5 AA size LR6
3.1.9 1 off operating instruction manual
3.2
Optional Accessories
3.2.1 Temperature Module (K-Type) 304A952
PrimeTest 200
Operating Instructions
2
Summary of Contents for PrimeTest 200
