3-27
3.6
Switching the Logger On/Off
The logger is switched on by moving the supplied magnet in front of the contact
area
. After the magnet switch has been activated, the I/O control lamp
is lit
green for a moment and starts flashing green after the logger has been started up.
The device is now in energy saving mode.
Whenever a connection to an E-Box is established and whenever a data transfer
takes place, the logger automatically switches to data transfer mode.
After the logger has been switched on, it automatically starts logging as specified in
its configuration. The device keeps logging even if a data transfer takes place or an
alarm is triggered.
In order to switch the logger off, the magnet must be held in front of the contact
area
for a few seconds while the I/O control lamp
is lit orange. As soon as the
lamp switches to red, the magnet has to be taken away from the contact area.
Afterwards, the logger switches off and the lamp goes out.
Make sure to take the magnet away immediately after the lamp switches to red.
Otherwise, the logger reboots right after it has been switched off. Check that the
lamp does not start flashing green again.
1
2
2
1
Summary of Contents for Sebalog D
Page 2: ......