5-51
5.6
Memory Mode
The logger has 2 MB internal memory. By default, the device stops logging as soon
as the memory is full.
By checking the Ring memory checkbox, the logger can be set to ‘ring buffer’ mode.
As the memory fills up with data in this mode, the device keeps logging and the
respective oldest value is overwritten.
By checking the Reset memory checkbox, the memory is cleared. Afterwards, you
have to confirm the deletion of the data. The memory is cleared as soon as the
configuration is transmitted to the logger.
5.7
State
Some characteristic data about the logger are listed under State. The data has been
derived during the last data or configuration readout. Amongst others, the remaining
memory in percent and the supply voltage are indicated.
If EXT is displayed instead of an actual voltage value, the logger is connected to an
external power supply.
5.8
Finishing the Configuration
Adding a comment
By adding a comment to the Comment field you can take some notes, e.g., on the
location of the logger.
Transmitting the
configuration data
Click on the Transmit configuration button in order to finalize the configuration
and to store the settings on the logger. Thereupon, the data is transmitted to the
logger.
After the settings have been saved on the device, a confirmation message appears.
If no connection to the logger can be established, an error message appears.
Check the link between logger and PC (see section 4.3) and try to transmit the data
again.
Summary of Contents for Sebalog D
Page 2: ......
