3
Required radio and motor
Radio equipment:
•
Minimum 4-channel radio system
•
4 digital mini servos, recommended JR PROPO DS 381
•
2 servo extension 300mm, for elevator and rudder servos
•
4 servo extension 100mm, for aileron’s servos
Recommended electric motors for best performance:
•
Hacker A30-12L + X40 cont APC 13 x 6.5 E
•
Hacker A30-14L + X40 cont APC 14 x 7 E
Additional required item, tools and adhesives
Tools:
•
Drill
•
Drill bits: 1,5mm
•
Phillips screwdriver
•
Hobby knife
•
Masking tape
•
Soldering iron
Adhesives:
•
thin CA
•
medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serius bodily harm and damage to property.
Fly only in open areas, preferably in official flying sites, following all instructions included with
your radio and engine.
Before starting assembly
Before starting the assebly of your KatanaS 30E, remove each part from its bag and protection for a
prior ispection. Closely inspect the fuselage, wing panels, rudder, and stabilizer for damage. If you
find any damage or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove them. Use
caution while working around areas where the covering material overlap to prevent separating the
covers.
Using the manual
This manual is divided into sections to help make assembly easier to understand and to provide
breaks between each major section.
